Home / Events

Upcoming events

Upcoming event
October 20-21, 2022
Come see us at the CH4 Connections Conference!

We'll be there to present our new methane detection service, which allows you to fly faster and increase your coverage.

Marketing director Frédérick Marcotte and president Jean Giroux will be there to answer any question you may have about how our system can help you visualize, identify and quantify gas leaks under various environmental conditions and industrial contexts. Learn how you can integrate one simple solution in your UAVs, helicopters or fixed-wing aircrafts and become an official partner.

Where: Fort Collins, Colorado

When: October 20-21

Conference website: https://www.gti.energy/training-events/ch4-connections
Upcoming webinar
2022-11-02
Telops used the TESTD Active thermography system with a long wave and Mid wave IR camera for a non-destructive approach for characterization of multi-layered panel paintings and analysis of their defects caused by aging and environmental effects. Two oil compositions painted on canvas, provided by the Louvre Museum were inspected. Active Thermography was demonstrated as being appropriate for characterization of various defects on painting layers and detection of underdrawings, pentimenti and analysis of preparatory layers and canvas, thus providing valuable insights to heritage science and restoration community. This is a promising analytical method for paintings inspection and efficient methodology to obtain valuable information on historical paintings, their preparation and painting procedure, preservation conditions, and defect analysis. The obtained data can be stored as Artwork unique finger print, which can help the curator to follow, identify and document the artworks.

Join Dr. Stéphane Boubanga Tombet from Telops, our expert for a high-level discussion in this next webinar.
Click here to register!

Past events

2022-09-22
Sulfur oxide (SOx) from seagoing ships contribute to local air pollution in cities and coastal areas around the world. Sulfur dioxide (SO2) emissions in particular, are a precursor to acid rain and atmospheric particulates leading to ocean acidification which can contribute to negative human health outcomes1. The International Convention for the Prevention of Pollution from Ships (MARPOL) defines limits on the sulfur content in ship fuel oils, since the sulfur is ultimately released into the atmosphere through the ship’s exhaust system as sulfur dioxide (SO2). The current approved method to verify compliance to these limits requires direct sampling and analysis of on-board fuel storage tanks by regulatory personnel, a complex, time consuming and costly task. The use of remote hyperspectral imaging data along with signal processing techniques can provide rapid and accurate estimation of sulfur content in fuel oils. This webinar will describe how the Hyper-Cam, a hyperspectral camera, was used to detect, image and quantify SO2 emissions from several seagoing ships and then retrieve the sulfur content of the fuel. The sulfur content results obtained from the hyperspectral dataset compare very well to the sulfur content in the fuel obtained from bunker delivery notes provided by the ship’s owner as well as in situ measurements performed by an approved regulatory organization. This system offers a distinct advantage over existing, more complex, and time-consuming sulfur monitoring techniques as it does not require direct sampling of the fuel or the ship exhaust emissions.

Join Benjamin Saute, Field Applications Engineer, from Telops, for a high-level discussion in this next webinar.
Click here to register!
September 5-7, 2022
Our partner SphereOptics will be at SPIE Sensors + Imaging in Berlin, Germany, this September (5-7).

They'll be more than happy to discuss our products with you!
July 24-29, 2022
Join us for the 39th International Combustion Symposium, in Vancouver, Canada.

We'll be happy to discuss with you of the benefits of our IR cameras for combustion analysis. See you in booth #109!
July 4 - 8, 2022
Join us in Paris, France, July 4 to 8!

We'll present a paper on the quantification of CO2 from passive degassing at Sulphur Banks, in Hawaii.
June 28 - 30, 2022
Join us in Houston, Texas, June 28 to 30, to learn how you can obtain methane quantification reports in real time, and fly faster while increasing your coverage.

Our marketing director Frédérick Marcotte will be able to answer all your questions.
June 27 - 30, 2022
Come join us at the A&WMA Annual Conference this June in San Francisco!

We will present a summary of the methane quantification capabilities of our airborne hyperspectral imaging systems on June 29, 9:00 am PT.

We'll be at booth # 311.

We'll be happy to see you there!
June 13 - 16, 2022
Come join us at the SEM Annual Conference this June!

We will present the benefits of high-speed infrared imaging for experimental mechanics during the Technology Applications sessions.

We'll be happy to see you there!
June 7 - 10, 2022
Come join us at the ITBMS Conference this June in France!

We will present a paper on thermal IR camera system design for high-dynamic-range imaging on June 7.

We'll be happy to see you there!
June 8 - 10, 2022
Come join us at the OPTRO Conference this June in France!

We will present a paper on airborne quantification of methane emissions for alternative leak detection and repair (LDAR) on June 10, 10:40 am

We'll be happy to see you there!
May 31 - June 3, 2022
Come join s at the SDT conference this end of May.

Telops will have a stand and will present a paper on methane detection, identification and quantification.

We'll be happy to see you there!
2022-05-05
The Hyper-Cam Mini xLW is an advanced compact IR hyperspectral imaging system that combines high spatial, spectral and temporal resolution for remote detection, identification, and quantification. It features small Size, Weight, and Power (SWaP) & high sensitivity over an expanded spectral range.

Join Jean-Philippe Gagnon (Field Applications Engineer) and Philippe Lagueux (Product Line Manager) from Telops, for a high-level discussion in this next webinar.
Click here to register!
2022-04-20
During this presentation, we will present the Imagetna campaign carried out at Mount Etna in 2015 involving researchers from French (LPC2E, ONERA, LATMOS) and Italian laboratories (INGV). The radiative transfer and data retrieval model LARA (LATMOS Atmospheric Retrieval Algorithm) will also be introduced. Results and maps gathered from the Telops Hyper-Cam will be presented and compared to SO2 UV-Vis camera measurements. The comparison highlights an underestimation of the SO2 UV-Vis measurements by a factor of ~3 to 4 compared to SO2 values obtained by IR.

Join Dr. Charlotte Segonne from Université Clermont Auvergne and Dr. Stéphane Boubanga Tombet from Telops, our experts for a high-level discussion in this next webinar.
Click here to register!
April 3-7, 2022
Telops will be at SPIE DCS this year.

We will announce product launches, perform product demonstrations, and more. Come see us at booth #1229.
2022-03-29
In order to better understand the dynamic behavior of CFRP and to improve numerical modeling tools for these materials, it is essential to better understand the effects of strain rate on damage initiation and growth. Unlike low loading rate mechanical tests, the experimental setup for intermediate strain rate tests is classically based on servo-hydraulic actuators. The higher the loading rate of such test equipment, the more complicated, if not impossible, it becomes to interrupt the loading without resorting to complex experimental setups. Consequently, the observation and monitoring of damage in CFRP during these tests is difficult to achieve with the usual techniques: optical microscopy, X-ray, CT-scan. To overcome this problem, it is possible to use high-speed infrared thermography, for example, to monitor the appearance of transverse cracks in cross-ply laminates at different loading rates [1, 2] or even the growth of delamination during impact tests. Join Stéphane Boubanga and Dr. Julien Berthe, our experts for a high-level discussion in this next webinar.

Join Dr. Julien Berthe from ONERA and Stephane Boubanga Field Applications Scientist at Telops for this virtual event.
Click here to register!
2022-03-17
The oil and gas industry uses flaring to dispose of methane and other hydrocarbons in a safe and ecologically sustainable manner compared to venting directly to the atmosphere. Under ideal conditions, this process is 98% efficient; however, under some conditions, this figure is significantly lower. Given that nearly 1 billion tonnes of methane is flared each year, and that each tonne of methane has a global warming potential nearly 28-36 times that of CO2 over 100 years, it is imperative to identify and correct flares that are operating under sub-optimal conditions.

Join Professor Kyle Daun from University of Waterloo and Jean-Philippe Gagnon Field Applications Scientist at Telops for this virtual event.
Click here to register!

Wednesday March 9th, 2022
Our Field Application Scientist Benjamin Saute will present his paper titled "Detection, Identification, and Quantification of Fugitive Methane Emissions Using Thermal Infrared Hyperspectral Imaging".

When? Wednesday March 9th, 1:35-2:00 PM Pacific

Join us by registering here : https://www.awma.org/measurementstechprogram.
2022-02-22
History teaches us that major breakthroughs in science and technology are always tied to the capability to observe nature. Advancing measurement techniques is critical in any research field. In this talk, I will discuss the development of high-resolution infrared thermometry, and the use of this technique to shed light on physical phenomena, focusing on flow boiling heat transfer. Flow boiling plays a central role in light water reactors (LWRs) thermal-hydraulics due to its exceptional heat transfer efficiency. The outcome of flow boiling results from many intertwined parameters. I will show how to perform direct measurement of key flow boiling parameters on different types of surface in steady state heating conditions. I will leverage these measurements to develop better understanding for flow boiling heat transfer. The outcome of my research should bring about the valuable power uprates of current LWRs and the better design for advanced reactors.

Contact: Stéphane Bounbanga
Click here to watch!
2022-01-27
Experimentally determining the velocities and temperatures of in-flight metallic feedstock particles during cold gas spraying is challenging. Recently, scientists at the Forschungszentrum Jülich GmbH used a state-of-the-art high-speed IR camera to investigate the behavior of two different feedstock materials, In718 and TiAlCrNb, both of which are used as structural materials in gas turbine engines.

Contact: Jean-Philippe Gagnon
Click here to watch!
December 13 - 17, 2021
Telops will be at AGU this December. Come see us at booth # 543!
2021-12-09
The HD and Super HD Series are high-performance infrared cameras that provide unprecedented image quality with crisp imaging of sharp targets while maintaining an excellent sensitivity. With real-time calibration, it provides unique capabilities in applications that require large image coverage. Discover more in this next webinar!

Contact:Benjamin Saute
Click here to watch!
November 15 - 18, 2021
Telops will be at ASNT this November. Come see us at booth # 749!
Université Laval's team of Formula SAE regularly participates in student racing competitions. Telops, who sponsors the team, had the unique opportunity to watch it perform tests on its electric vehicle before the Toronto Shootout... Visit this page to see what it looks like in infrared!
2021-10-26
In this webinar we will discuss the implementation and performances of infrared deflectometry and demonstrate how this new approach broadens the range of materials and surfaces that can be tested using the deflectometry technique. The results reported here provide a path toward a widespread use of this technology for topography or surface vibration measurements.

Contact:Stéphane Boubanga
Click here to watch!
October 19 - 20, 2021
Telops will be presenting at Mega Symposium this October. Presentation will be about the management of VOC emissions. Don't miss it!
2021-10-14
The Hyper-Cam Airborne Mini is a state-of-the-art thermal infrared hyperspectral imaging system designed for use on a wide-variety of manned and unmanned aerial platforms. Join Telops Field Application Engineer Benjamin Saute for a look at this latest entry to the Telops hyperspectral product line. This webinar will serve as an introduction to the Hyper-Cam Airborne Mini, providing attendees with a detailed description of the hardware and underlying technology that make this product unique. Finally, we will show the Hyper-Cam Airborne Mini in action by highlighting key applications including gas detection, identification, and quantification, airborne geological exploration and mapping, and environmental research and compliance.

Contact:Benjamin Saute
Click here to watch!